Krone Comprima CF 155 XC - Adjusting Soft Core

Operation
246
Pos: 55.142 /Übersc hriften/Überschr iften 2/U-Z/Weic hkern anpassen @ 58\mod_129716 9012752_78.docx @ 55550 3 @ 22 @ 1
11.16 Adjusting Soft Core
Pos: 55.143 /Abkürzu ngen /Abkürzungen sprac hneutral/Rundbal lenpressen/Compri ma CV 150 / CV 210 XC @ 199\mod_138493950 5399_0.docx @ 1676121 @ @ 1
Comprima CV 150 / CV 210 XC
Pos: 55.144 /BA/Bedienu ng /Rundballenpresse/ Bild Anpassen W eichkern @ 59\mod_129717269 8438_78.docx @ 555798 @ @ 1
VPN00012
4
5
6
Fig. 188
Pos: 55.145 /BA/Bedienu ng /Rundballenpresse/ Anpassen Weic hkern @ 59\mod_1297172819339_ 78.docx @ 555825 @ @ 1
To adjust the soft core, move the baling path of the front feeder rake (4) to the right and left:
• Remove the screw (5)
• Move the stop (6) one borehole to the right or left (see positions below)
• Install and tighten the screw (5)
Note
Make sure that the stop (6) on the right-hand and left-hand side of the machine is set equally.
Pos: 55.146 /Layout Mod ule /---------- -----Seitenumbruc h------------- --- @ 0\mod_1196175311226_ 0.docx @ 4165 @ @ 1