KRONE ISOBUS Terminal
140
Pos: 48.98 /BA/Inf o-Center/CCI-I SOBUS-Terminal/CCI-Pr ess-Wickelvorric htung/Hauptmenüs/ Hauptmenü 1 Einstellungen/ Menü 1-3-6 Folienr isskontrolle CF/CV XC @ 233\ mod_1393939639108_78. docx @ 1858945 @ 33 @ 1
8.8.6 Menu 1-3-6 Torn sheet control
CC000277
1-3-6
AUT O
mm
Fig. 102
Displaying the menu
Menu 1-3 "Wrapper setting" is called.
• You can select menu 1-3-6
by pressing function key or . The symbol is
highlighted in grey.
• Press function key
.
The display shows menu 1-3-6 "Sheet tear monitoring".
The current status is displayed as an icon:
= No sheet tear monitoring
= Stop for sheet tear
1/2
allow one-sided sheet tear
Note
Allow one-sided sheet tear means that the wrapping process is continued after a one-sided
sheet tear with accordingly changed values. The nominal speed has to be observed, when a
one-sided sheet tear is existent (540 U/min).
The “one-sided sheet tear” message appears after the wrapping process is complete.
Change and save status
• Set the desired status via function key
or , the symbol in the upper line goes out.
• Press function key
.
The symbol
in the upper line indicates that the displayed value is saved.
• Use softkey DEF to reset the sheet tear monitoring to the factory setting.
• Pressing the function key
closes the called up menu.
• Pressing the function key longer
and holding it down brings up the basic screen.