Operation
211
Pos: 55.9 /BA/Bedienung / Rundballenpresse/ hohe Ballendichte @ 35\ mod_1256125227222_78. docx @ 326331 @ @ 1
If the cutting system is switched on during baling, the bale density will increase
substantially, which makes it necessary to reduce the baling pressure.
Pos: 55.10 /BA/Bedienun g /Rundballenpresse/ Kurzes Stroh @ 66\mod_1 302508002442_78.d ocx @ 616455 @ @ 1
To do this:
Short, crumbly straw:
• Reduce the number of cutting blades or turn off the cutting system or remove the cutters.
The blades can be stored on the left-hand side of the machine
• Switch off P.T.O. shaft in headland position
Small, flat swaths:
• Reduce PTO speed
or
• Increase travelling speed
Straw varies greatly in structure. Even if no cutting system is used, it is not always possible to
work with the highest possible pressure.
Pos: 55.11 /BA/Bedienun g /Rundballenpresse/ Einstellung anpas sen @ 66\mod_130250806680 0_78.docx @ 616483 @ @ 1
Adapt the round baler setting to prevailing conditions.
Pos: 55.12 /BA/Sic herheit/7. Gefahrenhin weise alt/Rundballe npresse/Hinweis Bli ndmesser @ 175\mod_1372 833769347_78.doc x @ 1504684 @ @ 1
Note
If the cutting system is not connected for long periods, the cutting blades can be replaced with
blind blades to prevent soiling of the slots on the blade base and wear to the blades.
The blind blades can be ordered from the KRONE spare parts department under part number
200654050.
Pos: 55.13 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1
To Next Page
Loading...
Need help?
General
