Krone Comprima CF 155 XC - Page 214

Operation
214
Pos: 55.21 /Abkürzun gen /Abkürzungen sprac hneutral/Rundbal lenpressen/Compri ma CV 150 / CV 210 XC @ 199\mod_1384939505 399_0.docx @ 1676121 @ @ 1
Comprima CV 150 / CV 210 XC
Pos: 55.22 /BA/Bedienun g /Rundballenpresse/ Hinweise Ballenka mmer befüllen @ 35\mod_125 6126740722_78.doc x @ 326461 @ @ 1
Note
Barrel-shaped round bales can cause damage to the floor conveyor. Distorted and thick round
bales are detrimental to proper silage production.
Note
To prevent overload on the round baler when handling certain types of crop (e.g. wet silage),
the baling pressure should be reduced. The baling pressure should never be set above 200
bar.
Pos: 55.23 /Abkürzun gen /Abkürzungen sprac hneutral/Rundbal lenpressen/Compri ma CF 155 XC_fett @ 66\mod_1302006 789716_78.docx @ 593531 @ @ 1
Comprima CF 155 XC
Pos: 55.24 /BA/Bedienun g /Rundballenpresse/ Hinweise Ballenka mmer befüllen CF @ 66\mod_1302 514167499_78.doc x @ 616925 @ @ 1
Note
The binding process should be started at the latest when the baling pressure indicators reach
the red range (the buzzer sounds if the comfort electronic system is fitted).
Note
To prevent overload on the machine when handling certain types of crop (e.g. wet silage), the
binding process should already be started at an earlier point.
Permanent overload of the machine can drastically reduce the service life.
Pos: 55.25 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1