Operation
267
Pos: 55.170.10.17 /BA/ Bedienung /Rundballe npresse/Gutfluss blockaden entferne n/Wenn die Blockade dadurc h nicht beseitigt ist: @ 194\mod_1383555273 315_78.docx @ 1649635 @ @ 1
If the blockage is not removed due to this:
Pos: 55.170.10.18 /BA/ Bedienung /Rundballe npresse/Gutfluss blockaden entferne n/Motor starten und Zapfwelle einschalten @ 212\ mod_1389783708405_78. docx @ 1742558 @ @ 1
• Start the tractor engine.
• Switch on the PTO shaft.
Pos: 55.170.10.19 /BA/ Bedienung /Rundballe npresse/Gutfluss blockaden entferne n/Ballenkammer über di e Bedieneinheit öffnen_C omprima CF/CV @ 212\ mod_1389776483662_78. docx @ 1741830 @ @ 1
• Open the bale chamber using the control unit.
Pos: 55.170.10.20 /BA/ Bedienung /Rundballe npresse/Gutfluss blockaden entferne n/Zapfwelle und Motor abstellen, Zündschlüss el ziehen @ 181\mod_137 7152868819_78.doc x @ 1555689 @ @ 1
• Switch off the PTO shaft and the engine of the tractor.
• Remove the ignition key.
Pos: 55.170.10.21 /BA/ Erstinbetriebn ahme/Rundballenpres se/Heckklappe sperr en Comprima @ 103\mod_133 2165161046_78.doc x @ 939811 @ @ 1
a
1
1
b
b
a
1
1
CPK00230_3
Fig.207
• Swivel the shut-off valve (1) of the left lifting cylinder from position (a) to position (b).
Tailgate is locked hydraulically.
Pos: 55.170.10.22 /BA/ Bedienung /Rundballe npresse/Gutfluss blockaden entferne n/Ballen entnehmen und Er ntegut manuell entferne n @ 181\mod_13771651 95517_78.docx @ 1557399 @ @ 1
• Remove the bale from the bale chamber (roll it out to the swath, if necessary).
– Remove accumulated crop manually.
Pos: 55.170.10.23 /BA/ Bedienung /Rundballe npresse/Gutfluss blockaden entferne n/Heckklappe hydrau lisch entriegeln_Com prima/Bellima @ 196\ mod_1384158668197_78. docx @ 1659266 @ @ 1
• Swivel the stop cock (1) of the left lifting cylinder from position (b) to position (a). The
tailgate is unlocked hydraulically.
Pos: 55.170.10.24 /BA/ Bedienung /Rundballe npresse/Gutfluss blockaden entferne n/Motor starten und Zapfwelle einschalten @ 212\ mod_1389783708405_78. docx @ 1742558 @ @ 1
• Start the tractor engine.
• Switch on the PTO shaft.
Pos: 55.170.10.25 /BA/ Bedienung /Rundballe npresse/Gutfluss blockaden entferne n/Ballenkammer über di e Bedieneinheit schlie ßen_Comprima CF/ CV @ 212\mod_1389778644487_7 8.docx @ 1742009 @ @ 1
• Close the bale chamber using the control unit.
Pos: 55.170.11 /Layout Module /------ ---------Seitenumbruc h---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1