Commissioning
64
Pos: 42.29 /BA/Er stinbetriebnahme/Rundba llenpresse/Deic hselhöhe einstellen C F_CV @ 66\mod_130200463350 3_78.docx @ 593369 @ @ 1
1
1
5
2
5
5
4
3
RPN00063
Fig.33
Note
Before starting the adjustment set the machine on the parking support and uncouple the tractor.
Adjusting the height of the drawbar:
• Loosen the safety nuts (3) until the drawbar (1) can be turned in the lock washer
connection.
• Adjust the drawbar (1) to the height of the tractor hitch.
To adjust the height of the hitch to the height of the tractor hitch (make setting on both
sides):
• Loosen the screw joint (4).
• Align towing ring (2) horizontal (parallel with the ground).
• Tighten the screw connections (3) and (4) to the appropriate torque.
Note
The lock washers (5) must intermesh.
Retighten the screw connections after 10 operating hours!
Pos: 42.30 /BA/W artung/Hinweis Anzugsmome nte beachten (siehe Kapit el Wartung „Drehmoment e“). @ 26\mod_12457362592 99_78.docx @ 263361 @ @ 1
Note
Mind the tightening torques (refer to chapter Maintenance “Tightening torques”).
Pos: 42.31 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1
To Next Page
Loading...
Need help?
General
