88C-21
AIR BAG AND PRETENSIONERS
Front side seat belt: Removal - Refitting
88C
III - FINAL OPERATION
a Connect the battery (see 80A, Battery, Battery: Re-
moval - Refitting, page 80A-2) .
a Unlock the airbag computer using the Diagnostic
tool (see Fault finding - Replacement of compo-
nents) (88C, Airbags and pretensioners).
IV - CHECKING AFTER REPAIR
a Check the correct operation by unrolling the front
side seat belt by 300 mm and letting it return twice
a Check that the front side seat belt locks correctly by
pulling the front side seat belt strap with increasing
speed 200 to 300 mm maximum until the inertia reel
locks.
a Switch on the ignition.
a Check that there are no faults on the instrument pan-
el.
WITH FRONT PRETENSIONER
IMPORTANT
To a void a fault with or even triggering of pyro-
technic components (airbags or pretensioners),
check the airbag computer using the diagnostic
tool.
IMPORTANT
To eliminate the risk of any accident, do not
reuse pyrotechnic components.
It is essential to destroy pretensioners or airbags
before scrapping a vehicle or a part only (see
Airbags and pretensioners: Recycling -
Destruction) .
WITH FRONT PRETENSIONER
To Next Page
Loading...
