82D-35
AFTER REPAIR
Carry out another fault finding check on the system.
Deal with any other faults.
Clear the stored faults.
V1
MR-453-X79-82D000$150.mif
ACCESS – SAFETY
Fault finding – Interpretation of commands
82D
UCH
Vdiag No.: 09
This command is used to recover a code which will allow the Techline to supply the After-Sales code.
Recovery procedure for Reserve code:
– Establish dialogue with the UCH.
– Select the menu Repair mode.
– Select the menu Programming.
– Select the line SC003 Spare.
Follow the instructions on the Clip diagnostic tool.
SC003
SPARE
Equipment required
CLIP
UCH_V09_SC003
To Next Page
Loading...
