82D-36
AFTER REPAIR
Carry out another fault finding check on the system.
Deal with any other faults.
Clear the stored faults.
V1
MR-453-X79-82D000$150.mif
ACCESS – SAFETY
Fault finding – Interpretation of commands
82D
UCH
Vdiag No.: 09
This key allocation operation enables you to assign keys to the vehicle.
To add one or more keys, replace one or more keys, de-allocate one or more keys (in the event of theft for example).
Before starting this operation, check that there are no components likely to interfere with the electromagnetic field
(for example: CB (Citizen Band), mobile phones, etc.).
The UCH must not be blank in order to be able to program keys.
With this system it is not possible to replace some components, such as the UCH and the key as these parts are sold
blank and uncoded.
SC015
ALLOCATE KEY
Equipment required
CLIP
IMPORTANT
It is not possible to allocate more than two blank keys per operation.
If more than two keys must be allocated: program 2 blank keys then repeat the procedure with all the keys.
WARNING
If not all of the keys are available, all the keys will have to be reallocated. Keys not inserted will no longer be
allocated to this vehicle.
WARNING
The only keys which can be submitted are those ordered for the vehicle concerned, or the vehicle's old keys.
IMPORTANT
Do not interrupt the procedure when it is in progress.
If it is interrupted, restart the procedure in "not connected mode"; a new programming key will be displayed.
UCH_V09_SC015
To Next Page
Loading...
