12A-7
FUEL MIXTURE
Air filter unit: Removal - Refitting
K4M
12A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Remove the air resonator (see 12A, Fuel mixture,
Air resonator: Removal - Refitting, page 12A-2) .
a Disconnect:
-the idle speed regulation stepping motor connector
(1) ,
-the connector (2) from the throttle position potenti-
ometer,
-the petrol vapour recirculation pipe (3) .
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Disconnect the vacuum pipe (4) from the brake ser-
vo on the inlet distributor
a Remove:
- the two bolts (5) from the air filter cover,
- the filter element.
a
Tightening torquesm
air filter unit bolts 9 N.m
116651
116552
WARNING
Do not damage the vacuum outlet on the inlet
distributor. If it is damaged, the inlet distributor
will have to be replaced.
To Next Page
Loading...
