19A-33
COOLING
Engine cooling fan assembly: Removal - Refitting
K9K
19A
REFITTING
I - REFITTING PREPARATION OPERATION
In the event of replacement
a Refit on the fan assembly:
-the power-assisted steering hose clips,
-the wiring clip,
-the support of the intercooler duct and coolant hose
on the fan assembly.
II - REFITTING OPERATION
a Proceed in the reverse order to removal.
a Connect the battery (see Battery: Removal - Refit-
ting) (80A, Battery).
III - CHECKING THE OPERATION OF THE FAN UNIT
a Start the engine.
a Disconnect the coolant temperature sensor connec-
tor.
a Check the operation of the fan assembly.
a Connect the coolant temperature sensor connector.
a Switch off the engine.
To Next Page
Loading...
