31A-16
FRONT AXLE COMPONENTS
Front brake disc: Removal - Refitting
31A
a Remove the brake pads (see 31A, Front axle com-
ponents, Front brake pads: Removal - Refitting,
page 31A-3)
a Remove the "brake calliper mounting - brake calli-
per" assembly (2) (see 31A, Front axle compo-
nents, Front brake calliper mounting: Removal -
Refitting, page 31A-11) .
a Hang the "brake calliper mounting - brake calliper"
assembly (2) on the suspension spring.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Remove:
- the brake disc bolt or bolts (3) ,
- the brake disc.
REFITTING
I - REFITTING PREPARATION OPERATION
a Clean the brake discs using a parts washer.
a Dry the surface of the discs.
a Clean the mating faces of the disc on the hub using
a wire brush and BRAKE CLEANER (see Vehicle:
Parts and consumables for the repair) (04B, Con-
sumables - Products).
a parts always to be replaced: Front brake disc
bolt
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit the brake disc with new bolts.
a Torque tighten the new disc mounting bolts (see
30A, General information, Brake circuit: Tighten-
ing torque, page 30A-6)
125059
125056
To Next Page
Loading...
