35A-2
WHEELS AND TYRES
Wheel: Removal - Refitting
35A
If this procedure does not work:
a Strike the inner surface of the wheel (2) using a mal-
let and a wooden block to detach it.
a Remove:
-the wheel bolts,
-the wheel.
REFITTING
I - REFITTING PREPARATION OPERATION
a Clean the hub carrier using a wire brush.
a Check the condition of the tyre.
a Do not move or remove the balance weights.
II - REFITTING OPERATION FOR PART
CONCERNED
a Clean the mating surfaces between the wheel and
the hub carrier using a wire brush.
a Coat the wheel-mating face (3) with COPPER ANTI-
SEIZE AGENT (see Vehicle: Parts and consum-
ables for the repair) (04B, Consumables - Prod-
ucts).
a Align the mark on the wheel with the mark made on
the hub when it was removed.
a Fit the wheel to the vehicle, positioning the valve at
the top.
a Insert the wheel bolts.
a Tighten the wheel bolts to bring all the bolt heads
into contact with the wheel.
106089
Note:
Do not strike the surface of the wheel using
excessive force as this may damage it.
Note:
there are two types of wheel bolts for alloy and
steel wheel rims; do not swap them.
124750
113180
To Next Page
Loading...
