Renault Duster 2007 - Page 54

10A-28
ENGINE AND CYLINDER BLOCK ASSEMBLY
Conrod bearing shell: Removal - Refitting
K9K
10A
a
Fit the head of the toolwith the marking " K9K INF "
on the threaded sleeve of the tool.
a Position the lower con rod bearing shell on the tool.
a
Fit the lower con rod bearing shell on the con rod
cap using the tool.
a Position the lower con rod bearing shell so that the
ends do not protrude beyond the con rod cap.
a Lubricate the surface of the con rod bearing shell
(crankshaft end) using new engine oil.
Note:
Always replace con rod bearing shells with a
width of 20 mm by con rod bearing shells with a
width of 18 mm.
If the set of con rod bearing shells only includes
con rod bearing shells which are 18mm wide,
only use the head of the toolwith the marking "
K9K SUP ".
133814
133815
Note:
The contact surface between the bearing shell
and the con rod must be dry and free of grease.