10A-31
ENGINE AND CYLINDER BLOCK ASSEMBLY
Conrod bearing shell: Removal - Refitting
K9K
10A
a Disconnect the crankshaft position sensor (4) to pre-
vent the engine from starting.
a Refit the oil filter (see 10A, Engine and cylinder
block assembly, Oil filter: Removal - Refitting,
page 10A-34)
a Fill up the engine oil (see 10A, Engine and cylinder
block assembly, Engine oil: Draining - Refilling,
page 10A-32) .
a Start the engine using the starter until the engine oil
warning light goes out.
a Connect the crankshaft position sensor.
a Refit the engine undertray.
a Clear the present faults using the Diagnostic tool.
123824
To Next Page
Loading...
