EasyManua.ls Logo

Renault Duster 2007 - Page 746

Renault Duster 2007
1162 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
61A-23
HEATING
Heater matrix: Removal - Refitting
LEFT-HAND DRIVE
61A
II - REFITTING OPERATION
a Refit the heater matrix.
a Refit:
-the heater matrix,
-the heater matrix bolts.
a Position the heater matrix pipes on the heater ma-
trix.
a Refit the heater matrix pipe clips.
III - FINAL OPERATION
a Refit:
-the strut,
-the two lower bolts on the strut, respecting the
marking made during the removal operation,
-the two upper nuts to the strut,
a Torque tighten:
-the upper nuts of the strut (21 N.m),
-the lower bolts of the strut (21 N.m).
a Position the floor carpet.
a Connect the heating resistor connector.
a Refit:
-the heating resistor relay mounting,
-the heating resistor relay mounting bolt.
a Clip on:
-the starter switch connector on its mounting.
-the wiring onto the strut.
a Clip the wiring onto the strut.
a Refit:
-the dashboard (see Dashboard: Removal - Refit-
ting) (57A, Interior equipment),
-the radio (see Radio: Removal - Refitting) (86A,
Radio),
-the storage compartment,
- the instrument panel (see Instrument panel: Re-
moval - Refitting) (83A, Instrument panel),
- the steering column switch assembly (see Steer-
ing column switch assembly: Removal - Refit-
ting) (84A, Control - Signals),
- the steering wheel (see Steering wheel: Removal
- Refitting) (36A, Steering assembly).
- the driver's front airbag (see Driver's frontal air-
bag: Removal - Refitting) (88C, Airbags and seat
belt pretensioners).
a Fit the heater hoses.
a Refit the clips on the heater hoses.
a Remove the hose clamps (Ms. 583).
a Connect the battery (see Battery: Removal - Refit-
ting) (80A, Battery).
a Fill the cooling circuit (see Cooling system: Drain-
ing - Refilling) (19A, Cooling).
a Bleed the cooling circuit (see Cooling system:
Draining - Refilling) (19A, Cooling).
a Check the cooling circuit (see Engine cooling sys-
tem: Check) (19A, Cooling).
a Unlock the airbag computer (see Fault finding - Re-
placement of components) (88C, Airbags and pre-
tensioners).
H79
Note:
Check that the floor carpet reaches under the
accelerator pedal end-stop.

Table of Contents

Related product manuals