62C-10
V1
MR-453-X79-62C000$020.mif
CLIMATE CONTROL
Fault finding – List and location of components
62C
– Low pressure pipe: This pipe connects the expansion valve, buffering capacity, evaporator and compressor inlet
in series (it is located in the engine compartment on the left-hand side).
• HEATING COMPONENTS
– Heater matrix: This is located at the bottom of the heating and air conditioning assembly.
– Heating resistors: These are located at the bottom of the heater matrix on the driver's side (depending on
the equipment).
• ACTUATORS:
– Air distribution flap: This is located in the heating and air conditioning assembly.
– Mixing flap: This is located in the heating and air conditioning assembly.
– Recirculation flap: This is located behind the dashboard.
• OTHERS
– Passenger compartment fan assembly: This is located in the heating and air conditioning assembly.
– Cooling fan assembly: This is located in the front panel of the vehicle, in front of the condenser.
– Air pipes: These are located underneath the dashboard.
To Next Page
Loading...
