82A-7
ENGINE IMMOBILISER
Battery for remote door locking control: Removal - Refitting
82A
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
a Remove the bolt (1) .
a Open the key with a flat-blade screwdriver at (2) .
a Remove the battery (3) using a flat-blade screwdriv-
er.
REFITTING
I - REFITTING PREPARATION OPERATION
a
II - REFITTING OPERATION FOR PART
CONCERNED
a Fit the battery (3) respecting the polarity.
III - FINAL OPERATION.
a Close the key.
a Refit the bolt (1) .
a Tighten the bolt.
107868
107869
107867
WARNING
To ensure that the remote control operates cor-
rectly, take care not to damage the battery con-
tacts.
Only handle the new battery with dry, grease-free
hands or wearing clean gloves to avoid any risk
of dirt and oxidation on the battery.
To Next Page
Loading...
