Renault Duster 2007 - Page 952

85A-10
WIPING - WASHING
Windscreen wiper mechanism: Removal - Refitting
85A
a Disconnect the windscreen wiper motor connector
(10) .
a Remove:
-the windscreen wiper mechanism bolts (11) ,
-the front windscreen wiper mechanism bolts (12) ,
-the washers.
a Remove the windscreen wiper mechanism.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
a Refit:
-the windscreen wiper mechanism,
-the washers,
-the windscreen wiper mechanism bolts,
-the windscreen wiper mechanism bolts.
a Torque tighten:
-the windscreen wiper mechanism bolts (8 N.m),
-the windscreen wiper mechanism nuts (8 N.m).
a Connect the windscreen wiper motor connector.
II - FINAL OPERATION
a Refit:
-the left-hand scuttle half-grille,
-the right-hand scuttle half-grille,
- the two scuttle panel grille side bolts,
- the engine compartment seal,
- the windscreen wiper mechanism bolt covers.
a Connect the battery (see 80A, Battery, Battery: Re-
moval - Refitting, page 80A-2) .
a Turn the wiper stalk from (0) to (1), and then from (1)
to (0).
a Refit the wiper arm (see 85A, Wiping - Washing,
Windscreen wiper arm: Removal - Refitting, page
85A-4) .
RIGHT-HAND DRIVE
121578
WARNING
To ensure that the wiper arms can travel
smoothly, the wiper motor must be initialised.