85A-13
WIPING - WASHING
Rear screen wiper motor: Removal - Refitting
85A
REFITTING
I - REFITTING PREPARATION OPERATION
a Replace the seal (3) if necessary.
II - REFITTING OPERATION FOR PART
CONCERNED
a Position and rivet the rear screen wiper motor (see
MR 400, 40A, General information).
a Connect the rear screen wiper motor supply connec-
tor.
III - FINAL OPERATION.
a Switch on the ignition.
a Move the wiper stalk from (0) to (1), then from (1) to
(0).
a Switch off the ignition.
a Refit:
-the tailgate trim (see Tailgate trim: Removal - Re-
fitting) (MR 389, 73A, Non-side opening elements
trim),
-the rear screen wiper arm (see 85A, Wiping -
Washing, Rear screen wiper arm: Removal - Re-
fitting, page 85A-11) .
125465
WARNING
To ensure that the wiper arms can travel
smoothly, the wiper motor must be initialised.
To Next Page
Loading...
