Shimadzu GC-2010 Plus - Page 351

331
GC-2010 Plus
OPTIMAL FLOW 157, 166
OPTION key 54, 197
O-ring for glass insert 285, 287
Oven Temperature 105
OVER TEMP PROTECTION 178
P
Parameter locking 269
Parameter log 187
PARITY 243
Parts 5
password 270
Peak Genarator 196
PF key 53, 54, 58
PF menu 58
power cable 16
Power consumption 265
Power source 16
power supply 4
Pre-Run Program 236
Pressure program 130
PRESSURE UNIT 255
Primary press 177, 256
Printing 273
Programmed analysis 107
Programmed temperature vaporizer injection
system
111
PROTOCOL 243
PURGE FLOW RATE 84
R
RAM 178
Ready Check 244
REAL TIME CLOCK REGISTOR 177
REMAIN TIME 97
Reset IC 178, 179
Restart GC 72
Retention time (Rt) 97
ROM 178
ROOM TEMPERATURE 177
RS-232C 27, 30
S
SAMPLING TIME 84, 126
Schedule number 214
Screen 55
Septum 120, 285, 287, 288
Septum purge flow rate 84, 136
SET key 53, 54, 83
Setting a numeric value 60
Setting the column 128
Setting the Output Signals 170
Setup value 55
SIGNAL ATTENUATION 152, 163
SIGNAL OUTPUT PORT 163
SIGNAL POLARITY 162
SIGNAL RANGE 152, 163
Silica wool 112, 113, 285, 296
SLEEP TIME 72
SPC 35
Split injection system 111, 122
Split mode 36, 38, 85, 126
Split ratio 34, 84, 126
Split ratio program 134
Splitless auto off 257
Splitless injection system 111, 122
Splitter fix 138
Standard Diagnosis 175
Standard Installation Test 194
START key 53, 54, 102, 103
Start Procedure 78
START TIME 72
Starting analysis 101
STATUS lamp 53, 56
STOP BIT 243
STOP key 53, 54, 103
Stop Procedure 80
STOP TIME 72
Stop Watch 266
Stopping analysis 103
SYSTEM key 53, 54
T
TCD 149
TEMP 106, 151, 161
TEMP lamp 53, 56
TEMP SENSOR DIAG 177
TEMP SENSOR USE TIME 177
temperature control signal 247
Temperature offset 254
Temperature Program 107
Ten keys 53, 54
TFC 34, 35, 36
Thermal conductivity detector 160
TIME 241
Time Program 230
Time Scheduler 213
Toggle key 54, 58
TOTAL FLOW RATE 84, 126
Total flow rate 34
Trap (Purge) 286, 301
Trap (s) 302
Trap (Split) 286, 301
Index
P-U