Parameters Description Unit
Z0 Reference point (abs) mm
X1 End point X ∅ (abs) or end point X in relation to X0 (inc) mm
Z1 End point Z (abs) or end point Z in relation to X0 (inc) mm
FS1...FS3 or R1...R3 Chamfer width (FS1...FS3) or rounding radius (R1...R3) mm
XF2 Undercut (alternative to FS2 or R2) mm
D Infeed depth (inc) – (for roughing only) mm
UX Final machining allowance in X direction (inc) – (for roughing only) mm
UZ Final machining allowance in Z direction (inc) – (for roughing only) mm
See also
Tool, offset value, feedrate and spindle speed (T, D, F, S, V) (Page 304)
Working in manual mode
5.6 Simple stock removal of workpiece
Turning
Operating Manual, 06/2019, A5E44903486B AB 149
To Next Page
Loading...
