9.12 Changing program blocks ....................................................................................................311
9.13 Changing program settings ..................................................................................................312
9.14 Selection of the cycles via softkey .......................................................................................314
9.15 Calling technology functions ................................................................................................319
9.15.1 Additional functions in the input screens..............................................................................319
9.15.2 Checking cycle parameters..................................................................................................319
9.15.3 Setting data for technological functions ...............................................................................319
9.15.4 Programming variables ........................................................................................................320
9.15.5 Changing a cycle call ...........................................................................................................320
9.15.6 Compatibility for cycle support ............................................................................................321
9.16 Programming the approach/retraction cycle ........................................................................322
9.17 Programming retraction to tool change point .......................................................................324
9.18 Measuring cycle support ......................................................................................................325
9.19 Example: Standard machining .............................................................................................326
9.19.1 Workpiece drawing...............................................................................................................327
9.19.2 Programming........................................................................................................................327
9.19.3 Results/simulation test .........................................................................................................339
9.19.4 G code machining program..................................................................................................341
10 Programming technology functions (cycles).............................................................................................345
10.1 Drilling ..................................................................................................................................345
10.1.1 General ................................................................................................................................345
10.1.2 Centering (CYCLE81) ..........................................................................................................346
10.1.3 Drilling (CYCLE82)...............................................................................................................348
10.1.4 Reaming (CYCLE85) ...........................................................................................................352
10.1.5 Boring (CYCLE86) ...............................................................................................................355
10.1.6 Deep-hole drilling 1 (CYCLE83)...........................................................................................357
10.1.7 Deep-hole drilling 2 (CYCLE830).........................................................................................363
10.1.8 Tapping (CYCLE84, 840).....................................................................................................373
10.1.9 Drill and thread milling (CYCLE78) ......................................................................................381
10.1.10 Positions and position patterns ............................................................................................384
10.1.11 Arbitrary positions (CYCLE802) ...........................................................................................386
10.1.12 Row position pattern (HOLES1)...........................................................................................390
10.1.13 Grid or frame position pattern (CYCLE801) ........................................................................393
10.1.14 Circle or pitch circle position pattern (HOLES2)...................................................................397
10.1.15 Displaying and hiding positions............................................................................................403
10.1.16 Repeating positions..............................................................................................................404
10.2 Rotate...................................................................................................................................406
10.2.1 General ................................................................................................................................406
10.2.2 Stock removal (CYCLE951) .................................................................................................406
10.2.3 Groove (CYCLE930) ............................................................................................................409
10.2.4 Undercut form E and F (CYCLE940) ...................................................................................412
10.2.5 Thread undercuts (CYCLE940)............................................................................................414
10.2.6 Thread turning (CYCLE99) ..................................................................................................417
10.2.7 Thread chain (CYCLE98).....................................................................................................434
10.2.8 Cut-off (CYCLE92) ...............................................................................................................440
10.3 Contour turning ....................................................................................................................442
Table of contents
Turning
Operating Manual, 06/2019, A5E44903486B AB 15
To Next Page
Loading...
