11. Longitudinal threads M48 x 2
(finishing)
1. Press the "Turning", "Thread" and "Thread longitudinal" softkeys.
The "Longitudinal thread" entry field opens.
2. Enter the following parameters:
T Threading tool_2 D1
Table without
P 2 mm/rev
G 0
S 995 rev/min
Machining type Finishing (∇∇∇)
Thread External thread
X0 48 abs
Z0 0 abs
Z1 -25 abs
LW 4 inc
LR 4 inc
H1 1.227 inc
αP 30 degrees
Infeed
NN 2
VR 1 inc
Multiple threads No
α0 0 degrees
3. Press the "Accept" softkey.
12. Drilling
1. Press the "Drilling", "Drilling reaming" and "Drilling" softkeys.
The "Drilling" input window opens.
2. Enter the following technology parameters:
T Drill_D5 D1 F 0.1 mm/rev V 50 m/min
Creating a ShopTurn program
9.19 Example: Standard machining
Turning
Operating Manual, 06/2019, A5E44903486B AB 337
To Next Page
Loading...
