Parameter Description Unit
Set machining area
limits
Set machining area limits
● Yes
● No
XA
XB
ZA
ZB
with limited machining area only, yes:
1st limit XA ∅
2nd limit XB ∅ (abs) or 2nd limit referred to XA (inc)
1st limit ZA
2nd limit ZB (abs) or 2nd limit referred to ZA (inc)
mm
N Number of grooves
DP Distance between grooves (inc) mm
* Unit of feedrate as programmed before the cycle call
Programming technology functions (cycles)
10.3 Contour turning
Turning
484 Operating Manual, 06/2019, A5E44903486B AB
To Next Page
Loading...
