Parameter Description Unit
FR Reduced feedrate mm/rev
Fixed
stop
Travel to fixed stop
● Yes
The counter-spindle stops at a defined distance away from transfer position Z1
and then traverses with a defined feedrate up to the fixed stop.
● No
The counter-spindle traverses to the transfer position Z1.
Parameter Description Unit
Function, withdrawing
Withdraw blank
● From main spindle
The blank is withdrawn from the main spindle
● From counter-spindle
The blank is withdrawn from the counter-spindle
Also take zero point Also take zero point
● Yes
● No
Work offset
- only when for "with‐
draw NP" "yes"
Work offset in which the coordinate system offset by Z1 must be saved.
● Basic reference
● G54
● G55
● G56
● G57
● ...
Z1 Amount by which the workpiece is withdrawn from the main spindle (inc)
F Feedrate mm/min
Parameter Description Unit
Machining side
function
Machining Selection of the spindle for machining:
● Main spindle
Machining on the main spindle
● Counter-spindle
Machining on the counter-spindle
Programming technology functions (cycles)
10.7 Additional cycles and functions in ShopTurn
Turning
656 Operating Manual, 06/2019, A5E44903486B AB
To Next Page
Loading...
