Parameter Description Unit
Work offset Selecting the work offset
Write to the
work offset
● Yes
Parameter ZV is displayed
● No
Parameter ZV is not displayed
ZV Z value of the work offset
The value exceeds the Z value in the selected work offset.
Blank
● Tube
● Cylinder
● Polygon
● Centered cuboid
ZA Initial dimension mm
ZI Final dimension (abs) or final dimension in relation to ZA (inc) mm
ZB Machining dimension (abs) or machining dimension in relation to ZA (inc) mm
XA Outside diameter – (only for tube and cylinder) mm
XI Inside diameter (abs) or wall thickness (inc) – (only for tube) mm
N Number of edges – (only for polygon)
SW or L Width across flats or edge length – (only for polygon) mm
W Width of the blank - (only for centered cuboid) mm
L Length of the blank - (only for centered cuboid) mm
S Speed limitation of the counter-spindle rev/min
Procedure
1. You have created programs for the multi-channel machining in the
job list and the parameter screen "Multi-channel data" is open in
the editor.
2. Enter the data for the cross-channel data.
3. Press the "Accept" softkey.
The multi-channel editor is opened and displays the programs that
have been created.
The cursor is positioned on an empty line before the cycle for the
job list (CYCLE208). You can also enter a comment.
Note:
Note that CYCLE208 must appear within the first 20 lines in job list
programs.
After the cycle call, enter the required initializations for the G code
program and add the program code.
Multi-channel machining
11.2 Multi-channel support
Turning
Operating Manual, 06/2019, A5E44903486B AB 671
To Next Page
Loading...
