Parameter Description Unit
Spindle chuck
data
● Yes
You enter spindle chuck data in the program.
● No
Spindle chuck data is transferred from the setting data.
Note:
Please observe the information provided by the machine manufacturer.
Spindle chuck
data
● Only chuck
You enter spindle chuck data in the program.
● Complete
You enter tailstock data in the program.
Note:
Please observe the information provided by the machine manufacturer.
ZC
● The main spindle chuck dimensions - (only for spindle chuck data "yes")
mm
ZS
● Stop dimension of the main spindle - (only for spindle chuck data "yes")
mm
ZE
● Jaw dimension of the main spindle for jaw type 2 - (only for spindle chuck data
"yes")
mm
Counter-spindle
Spindle chuck data
● Yes
You enter spindle chuck data in the program.
● No
Spindle chuck data is transferred from the setting data.
Note:
Please observe the information provided by the machine manufacturer.
Spindle chuck data
● Only chuck
You enter spindle chuck data in the program.
● Complete
You enter tailstock data in the program.
Note:
● Please observe the information provided by machine manufacturer.
Jaw type Selecting the jaw type of the counter-spindle. Dimensions of the front edge or stop
edge - (only if spindle chuck data "yes")
● Jaw type 1
● Jaw type 2
ZC The counter-spindle chuck dimensions - (only for spindle chuck data "yes") mm
ZS Stop dimension of the counter-spindle - (only for spindle chuck data "yes") mm
ZE Jaw dimension of the counter-spindle for jaw type 2 - (only for spindle chuck data
"yes")
mm
XR Tailstock diameter - (only for spindle chuck data "complete" and tailstock that has
been set up)
mm
ZR Tailstock length - (only for spindle chuck data "complete" and tailstock that has been
set up)
mm
Mirroring Z
● Yes
Mirroring is used when machining on the Z axis
● No
Mirroring is not used when machining on the Z axis
Multi-channel machining
11.2 Multi-channel support
Turning
670 Operating Manual, 06/2019, A5E44903486B AB
To Next Page
Loading...
Need help?
General
