Parameter Description Unit
XRI - only for a pipe blank
retraction plane X internal ∅ (abs) or
retraction plane X referred to XI (inc)
mm
ZRA Retraction plane Z front (abs) or
retraction plane Z referred to ZA (inc)
rev/min
ZRI Retraction plane Z rear – only for retraction "all" mm
Tailstock
● Yes
● No
XRR Retraction plane tailstock – only "Yes" for tailstock mm
Tool change point Tool change point, which must be approached by the revolver with its zero point.
● WCS (Workpiece Coordinate System)
● MCS (Machine Coordinate System)
Notes
● The tool change point must be far enough outside the retraction area that it
is not possible for any tool to protrude into the retraction area while the
revolver is moving.
● Ensure that the tool change point is relative to the zero point of the revolver
and not the tool tip.
XT Tool change point X ∅ mm
ZT Tool change point Z mm
SC The safety clearance defines how close the tool can approach the workpiece in
rapid traverse.
Note
Enter the safety clearance without sign into the incremental dimension.
mm
Mach. direction of rota‐
tion
Milling direction
● Conventional
● Climbing
Program header without multi-channel data
If a program is to be executed through one channel, then deselect multi-channel data. You then
have the option of entering cross-program values into the program header as usual.
Parameter Description Unit
Multi-channel
data
● No
This is only possible if you are not using a job list.
Measurement unit The setting of the measurement unit in the program header only refers to the
position data in the actual program.
All other data, such as feedrate or tool offsets, are entered in the unit of measure
that you have set for the entire machine.
mm
inch
Multi-channel machining
11.2 Multi-channel support
Turning
Operating Manual, 06/2019, A5E44903486B AB 679
To Next Page
Loading...
