Parameter Description Unit
Data for
● Main+counterspindle
All values for the main and counterspindle are saved in one data set
● Main spindle
Data set for the main spindle
● Counterspindle
Data set for the counterspindle
If the machine does not have a counterspindle, then the entry field "Data for" is not
applicable.
Work offset The work offset in which the zero point of the workpiece is saved.
You can also delete the default value of the parameter if you do not want to specify
a work offset.
write to
● Yes
Parameter ZV is displayed
● No
Parameter ZV is not displayed
ZV Z value of the work offset
For G54, the Z value is entered into the work offset.
Note:
Please observe the machine manufacturer's data
Blank Define the form and dimensions of the workpiece:
● Cylinder
XA Outer diameter ∅ mm
● Polygon
N Number of edges
SW / L Width across flats/edge length
● Centered cuboid
W Width of blank mm
L Length of blank mm
● Tube
XA Outer diameter ∅ mm
Inner diameter ∅ (abs) or wall thickness (inc) mm
ZA Initial dimension mm
ZI Final dimension (abs) or final dimension in relation to ZA (inc) mm
ZB Machining dimension (abs) or machining dimension in relation to ZA
(inc)
Retraction The retraction area indicates the area outside of which collision-free traversing of
the axes must be possible.
● simple
XRA
Retraction plane X external ∅ (abs) or
retraction plane X referred to XA (inc)
mm
XRI
- only for "pipe" blank
Retraction plane X internal ∅ (abs) or
retraction plane X referred to XI (inc)
mm
Multi-channel machining
11.2 Multi-channel support
Turning
680 Operating Manual, 06/2019, A5E44903486B AB
To Next Page
Loading...
