Parameters Description Unit
Work offset Work offset in which the coordinate system, which was shifted according to ZW
and by ZV as well as mirrored in Z, must be saved:
● Basic reference
● G54
● G55
● G56
● G57
● ...
Write to the
work offset
● Yes
The Z value of the work offset can be directly written to the input screen form.
● No
The actual Z value of the work offset is used.
ZV - only for
work offset
write "yes"
● Offset Z = 0 (abs)
● Workpiece zero is offset in Z direction (inc, the sign is also evaluated)
mm
Z4W Supplementary axis of the counter-spindle machining position (abs); MCS mm
Complete transfer
function
Front side (for counter-spindle in main spindle)
Work offset Work offset in which the coordinate system, which was shifted according to ZP
and by ZV as well as mirrored in Z, must be saved:
Basic reference
G54
G55
G56
G57
...
Work offset
write to
● Yes
The Z value of the work offset can be directly written to the input screen form.
● No
The actual Z value of the work offset is used.
ZV - only for
work offset
write "yes"
● Z value of the work offset (abs)
● Workpiece zero offset in the Z direction (inc); the sign is also evaluated.
mm
Z4P Park position of the counter-spindle supplementary axis (abs); MCS mm
Parameters Description Unit
Function, gripping Teaching in the park position and angular offset is possible
Gripping a blank
● With counter-spindle
The blank is gripped with the counter-spindle
● With main spindle
The blank is gripped with the main spindle
Also take zero point
● Yes
● No
Multi-channel machining
11.2 Multi-channel support
Turning
708 Operating Manual, 06/2019, A5E44903486B AB
To Next Page
Loading...
