Parameters Description Unit
Work offset
- for take zero point
"yes"
Work offset in which the coordinate system offset by Z1 must be saved.
Basic reference
G54
G55
G56
G57
...
Coordinate
system
● MCS
The park position is specified in the machine coordinate system. Teaching in the
park position and angular offset is only possible in the machine coordinate
system.
● WCS
The park position is specified in the workpiece coordinate system.
XP Park position of tool in X direction (abs) mm
ZP Park position of tool in Z direction (abs) mm
Flush chuck Flush counter-spindle chuck
● Yes
● No
DIR Direction of rotation
● Spindle rotates clockwise
● Spindle rotates counter-clockwise
● Spindle does not rotate
S Spindle speed – (only when the spindles rotate) rev/min
α1 Angular offset Degrees
Z1 Transfer position (abs.)
ZR Position, feedrate reduction (abs or inc)
Position from which a reduced feedrate is used.
FR Reduced feedrate mm/rev
Fixed
stop
Travel to fixed stop
● Yes
The counter-spindle stops at a defined distance away from transfer position Z1
and then traverses with a defined feedrate up to the fixed stop.
● No
The counter-spindle traverses to the transfer position Z1.
Parameters Description Unit
Function, withdrawing
Withdraw blank
● From main spindle
● From counter-spindle
Also take zero point Also take zero point
● Yes
● No
Multi-channel machining
11.2 Multi-channel support
Turning
Operating Manual, 06/2019, A5E44903486B AB 709
To Next Page
Loading...
