Stoll CMS 520 C+ - Page 319

319
Setup Data 5
Setup2 Editor
Further information:
 Table Tools [316]
 File tools [317]
 Helpers for Input [311]
 Overview of the Setup2 Editor
of the CMS [
309]
 Setup Data [303]
 Comparing Setup1 to Setup2 [305]
WMC Set the speed control of the active
take-down system (main take-down or
comb take-down) to the value n (0-
32). If the take-down system turns too
quickly, the machine is stopped.
0= no stop motion, 1= insensitive, 32=
very sensitive
Minimum value: 0
Maximum value: 32
Step width: 1
WM+C Monitoring of main take-down. If the
take-down has not been used after n
(0-100) knitting rows, the machine will
stop. (0 = no supervision)
Minimum value: 0
Maximum value: 100
Step width: 1
WMK+C Controlling the comb. If the comb has
not moved after n (0-100) knitting
rows, the machine will stop. (0 = no
supervision)
Minimum value: 0
Maximum value: 100
Step width: 1
Comment Comment ASCII Characters
Explanation Value range