505
Software - Installation and basic settings 8
Installing the Stoll operating system
7. If necessary, change the data and confirm the changes.
8. Proceed to the next window.
The "Machine Parameter" window is displayed. The data is set at the
factory.
9. If necessary, change the data and confirm
the changes.
10. Proceed to the next window.
Th
e "Needle bed parameters" window is displayed. The data is set at
the factory.
11
. If necessary, change the data and confirm
the changes.
12. Proceed to the next window.
Th
e "NPK-Values" window is displayed. The data is set at the factory.
13. I
f other NPK values are to be used
, change the values and confirm the
changes.
14. Proceed to the next window.
Th
e "Knit Report Configuration" window is displayed.
15. If other s
ettings are to be used, change the settings an
d confirm the
changes. Use the "additional function keys" to activate/deactivate the
running time control and/or running time measurement.
16. Proceed to the nex
t window.
Th
e configuration is complete.
The
"Reference runs" window is displayed.
17. Carry out reference run(s).
18. Proceed to the next window.
The
restart is complete and the
"Main menu" is displayed.
The machine is ready to knit.
Further information:
Setting touch screen [80]
Setting machine parameters [197]
Setting waiting time until warm start [473]
Configure machine [474]
Configuring network [476]
Machine fault!
The presence or lack of machine options must correctly be
s
pecified, as otherwise a fault may occur on the machine.
Always specify the machine optio
ns correctly.
To Next Page
Loading...