Toyota 22R-E - Engine Installation; Place Engine with Transmission in Vehicle; Install Engine Mounting to Frame Bracket; Install Engine Rear Mounting and Bracket (2 WD)

ENGINE INSTALLATION
1. (M/T)
INSTALL CLUTCH DISC AND COVER TO FLY–
WHEEL
(See CL section)
2. CONNECT TRANSMISSION TO ENGINE
3. PLACE ENGINE WITH TRANSMISSION IN VEHICLE
(a) Attach the engine hoist chain to the lifting brackets on
the engine.
(b) Lower the engine with transmission into the engine
compartment.
4. (4WD)
PLACE JACK UNDER TRANSMISSION
Be sure to put a wooden block between the jack and
the transmission pan.
5. JACK UP AND PUT TRANSMISSION ONTO
MEMBER
6. INSTALL ENGINE MOUNTING TO FRAME BRACK–
ET
(a) Align the engine mounting and frame bracket.
(b) Install the engine mounting bolts on each side of the
engine.
(c) Remove the hoist chain.
7. (2WD)
INSTALL ENGINE REAR MOUNTING AND BRACKET
(a) Raise the transmission slightly by raising the engine
with a jack and a wooden block under the transmis–
sion.
(b) Install the engine rear mounting bracket to the sup–
port member. Torque the bolts.
Torque: 13 N–m (130 kgf–cm, 9 ft–lbf)
(c) Lower the transmission and rest it on the extension
housing.
(d) Install the bracket to the mounting. Torque the bolts.
Torque: 25 N–m (260 kgf–cm, 19 ft–lbf)
Torque: M/T 108 N–m (1,100 kgf–cm, 80 ft–lbf)
A/T 83 N–m (850 kgf–cm, 61 ft–Ibf)
–ENGINE ENGINE MECHANICAL
EG1–71