Toyota 22R-E - Remove No.1 Water By-Pass Pipe; Remove Oil Pressure Sender Gauge; Remove Knock Sensor; Remove Oil Cooler and Bracket Assembly (2 WD)

8. REMOVE No.1 WATER BY–PASS PIPE
Remove the two nuts, two bolts and water by–pass
pipe.
9. REMOVE THERMOSTAT
12. REMOVE OIL PRESSURE SENDER GAUGE
Using SST, remove the oil pressure sender gauge.
SST 09816 – 30010
13. REMOVE OIL FILTER
15. (2WD)
REMOVE OIL COOLER AND BRACKET ASSEMBLY
(a) Remove the No.1 and No.2 oil cooler hoses.
10. REMOVE WATER PUMP
Remove the seven bolts and water pump.
11. REMOVE GENERATOR ADJUSTING BAR
14. REMOVE KNOCK SENSOR
Using SST, remove the knock sensor.
SST 09817–16011
–ENGINE ENGINE MECHANICAL
EG2–96