11. DISCONNECT STRAP, WIRES, CONNECTORS.
HOSES AND CABLES
(a) Disconnect the following strap, wires and connectors:
• Ground strap from LH fender apron
• Generator connector and wire
• Igniter connector
• Oil pressure sender gauge connector
• Ground strap from engine rear side
• ECM connectors
• VSV connectors
• A/C compressor connector
• (M/T only)
Starter relay connector
• Solenoid resister connector
• Data link connector 1
(w/ ADD)
ADD switch connector
(b) Disconnect the following hoses:
• PS air hoses from gas filter and air pipe
• Brake booster hose
• (w/ Cruise Control System)
Cruise control vacuum hose
• Charcoal canister hose from canister
• VSV vacuum hoses
(c) Disconnect the following cables:
• Accelerator cable
• (A/T only)
Throttle cable
• (w/ Cruise Control System)
Cruise control cable
12. DISCONNECT HEATER HOSES
13. DISCONNECT FUEL INLET AND OUTLET HOSES
9. REMOVE COOLING FAN
Remove the four nuts and cooling fan.
10. REMOVE GENERATOR DRIVE BELT
–ENGINE ENGINE MECHANICAL
EG2–52
To Next Page
Loading...
