8. REMOVE OIL PAN BAFFLE PLATE
Insert the blade of SST between the cylinder block
and baffle plate, cut off applied sealer and remove the
baffle plate.
SST 09032 – 00100
HINT: When removing the baffle plate, be careful not
to damage the baffle plate flange.
OIL PUMP DISASSEMBLY
(See components)
1. REMOVE DRIVEN AND DRIVE ROTORS
(a) Remove the seven screws and pump body cover.
(b) Remove the drive and driven rotors.
9. REMOVE OIL PUMP
(a) Remove the seven bolts and oil pump.
(b) Using a plastic–faced hammer, carefully tap the oil
pump body.
(c) Remove the O–ring from the cylinder block.
7. REMOVE OIL STRAINER
Remove the two bolts, two nuts, oil strainer and
gasket.
2. REMOVE RELIEF VALVE
(a) Unscrew the relief valve plug and gasket.
(b) Remove the spring and relief valve.
–ENGINE LUBRICATION SYSTEM
EG2–281
To Next Page
Loading...
