Toyota 22R-E - Repack Front Wheel Bearings and Thrust Bush; Lubricate Propeller Shaft (4 WD)

(g) Check that the fluid level is in the ”HOT” range at the
normal operating temperature (70 – 80
 C or 158 –
176 *F) and add as necessary.
NOTICE: Do not overfill.
27. REPACK FRONT WHEEL BEARINGS AND THRUST
BUSH
(a) Change the front wheel bearing grease.
(See SA section)
2WD –
Grease grade:
Lithium base multipurpose grease (NLGI No.2)
Wheel bearing friction preload (at starting):
5.9–18N(0.6–1.8kgf,1.3–4.OIbf)
4WD –
Grease grade:
Lithium base multipurpose grease (NLGI No.2)
Wheel bearing friction preload (at starting):
27 – 55 N (2.8 – 5.6 kgf, 6.2 – 12.3 lbf)
(b) Repack the drive shaft thrust bush grease.
(See SA section)
28. (4WD)
LUBRICATE PROPELLER SHAFT
Lubricate propeller shaft, referring to the lubrication
chart. Before pumping in grease, wipe off any mud
and dust on the grease fitting.
Grease grade:
Propeller shaft (ex. Double–cardan joint) –
Lithium base chassis grease (NLGI No.2)
Double–cardan joint – Molybdenum disulphide
Lithium base chassis grease (NLGI No.2)
–MAINTENANCE MAINTENANCE OPERATIONS
MA–21