PREPARATION FOR DISASSEMBLY
(See Components)
1. REMOVE FLYWHEEL OR DRIVE PLATE
(a) Remove the eight bolts.
(b) (M/T)
Remove the flywheel.
(c) (A/T)
Remove the rear plate, drive plate and front spacer.
4. REMOVE RH AND LH ENGINE MOUNTING
BRACKETS
Remove the four bolts and mounting bracket. Remove
the two mounting brackets.
2. REMOVE REAR END PLATE
Remove the bolt and rear end plate.
3. INSTALL ENGINE STAND FOR DISASSEMBLY
6. REMOVE TIMING BELT
(See pages EG2–33 to 38)
7. REMOVE CYLINDER HEADS
(See pages EG2–53 to60)
5. REMOVE ENGINE COOLANT DRAIN PLUGS
–ENGINE ENGINE MECHANICAL
EG2–95
To Next Page
Loading...
