COLD START INJECTOR INSTALLATION
(See Components for Removal and Installation)
1. INSTALL COLD START INJECTOR
(a) Apply sealant to 2 or 3 threads of the bolt end.
Sealant: Part No. 08833–00070, THREE BOND 1324 or
equivalent
HINT: This adhesive will not harden while exposed to
air.
It will act as a sealant or binding agent only when
applied to threads, etc., where air is cut off.
(b) Place a new gasket and install the cold start injector
with the two nuts.
Torque: 7.8 N–m (80 kgf–cm, 69 in.–lbf)
2. INSPECT LEAKAGE
(a) Disconnect the test probes of SST from the battery
and check fuel leakage from the injector.
SST 09842–30050
Fuel drop:
One drop or less per minute
(b) After checking, remove SST and restore the following
parts to their original positions.
• DLC1
• Ignition switch OFF
• Cold start injector
• Injector connector
(f) Connect the test probes of the SST to the battery and
check that the fuel injection is as shown.
SST 09842–30050
NOTICE: Perform this check within the shortest possible
time.
–ENGINE MFI SYSTEM
EG2–210
To Next Page
Loading...
