12. SET TIMING BELT TENSIONER
(a) Using a press, slowly press in the push rod using 981
– 9,807 N (100 – 1,000 kgf, 200 – 2,205 lbf) of
force.
(b) Align the holes of the push rod and housing, pass a
1.5 mm hexagon wrench through the holes to keep
the setting position of the push rod.
(c) Release the press.
13. INSTALL TIMING BELT TENSIONER
(a) Temporarily install the belt tensioner with the two
bolts.
(b) Alternately tighten the two bolts.
Torque: 26 N–m (270 kgf–cm, 20 ft–lbf)
11. INSTALL FAN BRACKET
(a) Install the gasket to the fan pulley bracket.
(b) Install the fan bracket with the two bolts and nut.
Torque: 41 N–m (420 kgf–cm, 30 ft–lbf)
(c) Using pliers, remove the 1.5 mm hexagon wrench
from the belt tensioner.
(d) Install the dust boot to the tensioner.
–ENGINE ENGINE MECHANICAL
EG2–45
To Next Page
Loading...
