5. INSTALL CAMSHAFTS
(a) Place the camshaft on the cylinder head.
(b) Apply seal packing to the No.1 and No.5 bearing caps
as shown.
Seal packing: Part No. 08826–00080 or equivalent
C. Install cylinder head (6 pointed head) bolts
(a) Apply a light coat of engine oil on the threads and
under the heads of the cylinder head bolts.
(b) Install the cylinder head bolt to each cylinder head.
Torque: 41 N–m (420 kgf–cm, 30 ft–lbf)
(c) Install the bearing caps in their proper locations.
–ENGINE ENGINE MECHANICAL.
EG2–78
To Next Page
Loading...
