Toyota 22R-E - Install Oil Cooler; Install Engine Coolant Drain Plugs; Install LH and RH Engine Mounting Brackets; Install Oil Filter

(c) Temporarily install the seal washer, oil cooler and seal
washer with the relief valve and bolt.
(d) Tighten the relief valve.
Torque: 59 N–m (600 kgf–cm. 43 ft–lbf)
(e) Install the bolt.
Torque: 39 N–m (400 kgf–cm, 29 ft–lbf)
10. INSTALL LH AND RH ENGINE MOUNTING
BRACKETS
Install the mounting bracket with the four bolts. Install
the two mounting brackets.
Torque: 39 N–m (400 kgf–cm, 29 ft–Ibf)
11. INSTALL OIL FILTER
8. (4WD)
INSTALL OIL COOLER
(a) Install new 0–ring and gasket to the oil cooler.
(b) Apply a light coat of engine oil on the threads of the
relief valve.
9. INSTALL ENGINE COOLANT DRAIN PLUGS
Torque: 29 N–m (300 kgf–cm, 22 ft–Ibf)
(f) Install the No.1 and No.2 oil cooler hoses.
–ENGINE ENGINE MECHANICAL
EG2–126