9. INSTALL INTAKE MANIFOLD
(a) Position a new gasket on the cylinder head.
(b) Install the intake manifold with the delivery pipe and
injectors and No. 1 air pipe.
(c) Install the seven bolts, one hexagon bolt and two nuts.
Torque the bolts and nuts.
Torque: 19Nm (195kgf–cm, 14ft–lbf)
(d) Install the heater inlet pipe to the cylinder head with
the bolt.
CYLINDER HEAD INSTALLATION
(See page EG1–15)
1. APPLY SEAL PACKING TO CYLINDER BLOCK
(a) Apply seal packing to two locations as shown.
Seal packing: Part No. 08826–00080 or equivalent
(b) Place a new head gasket over dowels on the cylinder
block.
2. INSTALL CYLINDER HEAD
10. INSTALL NO. 1 SECONDARY AIR INJECTION
MANIFOLD
(a) Position new gaskets on the PAIR valve and No. 1
secondary air injection pipe.
(b) Install the No. 1 secondary air injection pipe with the
four nuts and bolt.
Torque: 13Nm (130kgf–cm. 9ft–lbf)
(e) Install the PAIR valve with the two nuts.
Torque: 13N–m (130kgf–cm, 9 ft–lbf)
(c) Install the EGR valve with the two bolts and nut.
–ENGINE ENGINE MECHANICAL
EG1–33
To Next Page
Loading...
