20. REMOVE OIL PAN BAFFLE PLATE
Insert the blade of SST between the cylinder block
and baffle plate, cut off applied sealer and remove the
baffle plate.
SST 09032 – 00100
NOTICE:
• Do not use SST for the oil pump and rear oil seal
retainer.
• Be careful not to damage the baffle plate flange.
21. REMOVE OIL PUMP
(a) Remove the seven bolts.
(b) Using a plastic–faced hammer, carefully tap oft the
oil pump.
(c) Remove the O–ring from the cylinder block.
19. REMOVE OIL STRAINER
Remove the two bolts, two nuts, oil strainer and
gasket.
–ENGINE ENGINE MECHANICAL
EG2–98
To Next Page
Loading...
