Toyota 22R-E - Check Valve Timing; Install No.2 Timing Belt Cover

(e) Using the two water outlet nuts, install the two stud
bolts.
(f) Connect the four clamps on the high–tension cords
to the mounting bolts of the No.2 timing belt cover.
(b) Check that each pulley aligns with the timing marks as
shown in the illustration.
If the timing marks do not align, remove the timing
belt and reinstall it.
14. CHECK VALVE TIMING
(a) Slowly turn the crankshaft pulley two revolutions
from TDC to TDC.
NOTICE: Always turn the crankshaft pulley clockwise.
15. INSTALL NO.2 TIMING BELT COVER
(a) Install the gasket to the No.2 idler pulley.
(b) Install the gasket to the fan bracket.
(c) Install the gasket to the timing belt cover.
(d) Install the timing belt cover with the eleven bolts.
–ENGINE ENGINE MECHANICAL
EG2–46