Toyota 22R-E - Inspect Negative Side Rectifier; Inspect Front Bearing; If Necessary, Replace Front Bearing

(b) Reverse the polarity of the tester probes.
(c) Check that one shows continuity and the other shows
no continuity.
If not, replace the rectifier holder.
2. INSPECT NEGATIVE SIDE RECTIFIER
(a) Connect one tester probe to each rectifier terminal and
the other to each rectifier negative terminal.
Bearings
1. INSPECT FRONT BEARING
Check that the bearing is not rough or worn.
2. IF NECESSARY, REPLACE FRONT BEARING
(a) Remove the four screws and bearing retainer.
(b) Using a press and socket wrench, press out the front
bearing.
–CHARGING SYSTEM Generator
CH–12