DISTRIBUTOR INSTALLATION
1. CHECK NO.1 CYLINDER TO TDC/COMPRESSION
2. INSTALL DISTRIBUTOR
(a) Install a new O–ring to the distributor.
HINT: Always use a new 0–ring when installing the
distributor.
3. REMOVE DISTRIBUTOR CAP AND DUST PROOF
PACKING
4. SET NO.1 CYLINDER TO TDC/COMPRESSION
(a) Turn the crankshaft pulley until the timing mark is
aligned with the ”0” mark on the No.1 timing belt
cover.
5. REMOVE DISTRIBUTOR
(a) Remove the hold–down bolt.
(b) Pull out the distributor from the cylinder head.
6. REMOVE O–RING
(b) Check that the distributor rotor direction is as shown.
If not, turn the crankshaft pulley one complete revo–
lution.
(b) Align the protrusion on the driven gear with the
groove of the distributor housing.
–IGNITION SYSTEM (3VZ– E)
IG–25
To Next Page
Loading...
