(b) Malfunction Code Indication
• The lamp will blink a number of times equal to the
malfunction code with pauses as follows: 1. Between
the first digit and second digit, 1.5 seconds. 2. Between
code and code, 2.5 seconds. 3. Between all malfunc-
tion codes, 4.5 seconds.
The diagnostic trouble code series will be repeated as
long as the DLC1 terminals TE1 and E1 are connected.
HINT: In the event of a number of trouble codes,
indication will begin from the small value and continue
to the larger in order.
(d) Accessories switched OFF.
(e) Engine at normal operating temperature.
2. Turn the ignition switch ON. Do not start the
engine.
3. Using SST, connect terminals TE, and E, of the DLC
1.
SST 09843–18020
HINT: The DLC1 is located near the No. 2 relay block.
4. Read the diagnostic trouble code as indicated by the
number of flashes of the Malfunction Indicator
Lamp.
(a) Normal System Operation
The lamp will blink 2 times per second.
Diagnostic trouble code (Seepage EG1–114 and 115)
–ENGINE MFI SYSTEM
EG1–111
To Next Page
Loading...
